10
Instructions for Use
Starting Cleaning
Press the button to start cleaning. The robot will plan its
cleaning route according to its scan of the room. It splits a room
into zones, first draws out zone edges, and then fills the zone in
a zigzag pattern. In doing so, the robot cleans all zones one by
one, efficiently cleaning the house. During cleaning, the robot
automatically determines when it should wash the mop and fill
the water tank to maximize its washing performance.
Notes:
• To allow the robot to wash the mop automatically, start the robot from the dock once it is fully
charged. Do not move the dock during cleaning.
• Cleaning cannot start when the battery is low. Allow the robot to charge before starting cleanup.
• If cleaning is completed in less than 10 minutes, the area will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot will automatically return to the dock.
After charging, the robot will resume where it left off.
• Automatic mop washing will not work if the dock encounters an error during cleaning. Wash the
mop manually to restore.
• The robot will retract the mop mount to clean the carpet. You can also set the carpet as a No-Go
Zone in the app to avoid it.
• Before starting each mopping task, make sure that the VibraRise mop has been properly
installed.
Spot Cleaning
Press the button to start spot cleaning.
Cleaning range: The robot cleans a 1.5 m (4.9 ft) x 1.5 m (4.9 ft)
square area centered on itself.
Note: After spot cleaning, the robot will automatically return to the starting point and enter
Standby mode.
Pause
When the robot is running, press any button to pause it, press the
button to resume cleaning, press the button to send it back
to the dock, hold and press the
button to wash the mop.
Note: Placing a paused robot on the dock manually will end the current cleanup.
Child Lock
Press and hold the button to enable/disable the child lock. You
can also set it in the app. Once enabled, the robot will not react to
button presses when it is stationary. When the robot is cleaning
or docking, press any button to stop it.
DND Mode
The default Do Not Disturb (DND) period is from 22:00 to 08:00.
You can use the app to disable the DND mode or modify the DND
period. When DND is on, the auto top-up is canceled, indicator
lights are dimmed, and voice alerts are quietened.
Sleep
If the robot is paused for over 10 minutes, it will go to sleep, and
the power indicator will flash every few seconds. Press any button
to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep mode for more than 12 hours.
Charging
After cleaning, the robot will automatically return to the dock to
charge.
In Pause mode, press the
button to send the robot back to the
dock. The power indicator will pulse as the robot charges.
Note: If the robot fails to find the dock, it will automatically return to its starting location.
Place the robot on the dock manually to recharge.
Resetting
If the robot does not respond when a button is pressed or cannot
be turned off, reset the system. Press the Reset button, and the
robot will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi, etc. will be restored to factory
settings.
To Next Page
Loading...
