EasyManua.ls Logo

Roborock G10 - Error Indicators and Solutions; Routine Maintenance; Maintenance Schedule

Roborock G10
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Instructions for Use
Error
If an error occurs, the power indicator will flash red and a voice
alert will sound. See “Errors” for solutions.
Notes:
The robot will go to sleep automatically if left in a malfunctioning state for over 10 minutes.
Placing a malfunctioning robot on the dock manually will end the current cleanup.
Restoring Factory Settings
If the robot does not function properly after a system reset, switch
it on. Press and hold the
button and at the same time press
Reset button until you hear the “Restoring factory settings” voice
prompt. The robot will then be restored to factory settings.
Cleaning Map
Multi-Map Management| Real-time Vacuum and Mop Route|
Carpet DisplayMap ZoningMap Editing
Custom Cleaning Modes
ScheduledSelective RoomZoneNo-Go Zones & Invisible
WallsCustomCarpet BoostMop Wash Interval Settings
Note: Functions and details of the app may vary slightly due to the continuous app
development and updates.
Cleaning Mode Switch
Suction PowerWashing IntensityMop Washing Modes
Custom Modes
Robot Information
Cleaning HistoryBattery LevelCare & Maintenance
More Features
Firmware Update|Volume Adjustment|Language Selection|
Do Not Disturb Mode|Voice Assistant Support
App Features
Routine Maintenance
To ensure optimal performance of the robot, refer to the following
table for routine maintenance:
The frequency of replacement may vary depending on the situation. If abnormal wear
occurs, replace the parts immediately.
Note:
Parts
Clean
Frequency
Replacement
Frequency
Omni-Directional Wheel As needed /
Dustbin As needed /
Water Tank As needed /
Main Brush Every two weeks Every 6-12 months
Side Brush Monthly Every 3-6 months
Washable Filter Every two weeks Every 6-12 months
VibraRise Mop After each use Every 3-6 months
Dock Locator Monthly /
Cliff Sensor Monthly /
Wall Sensor Monthly /
Carpet Sensor Monthly /
Main Wheel Monthly /
Charging Contacts Monthly /
Dock Charging Contacts,
Location Beacon, and Robot Body
Monthly /
Water Filter As needed /
Clean Water Tank and Dirty Water Tank As needed /
High-Speed Maintenance Brush As needed Every 6-12 months

Related product manuals