Roborock G10 - Component Maintenance

12
1. Turn over the robot and press the
latches to remove the main brush
cover.
Routine Maintenance
Main Brush
2. Pull out the main brush and remove
the main brush bearing.
Latches
Main Brush Caps
Main Brush Bearing
Main Brush Cover
Main Brush
3. Rotate the main brush caps in the
indicated unlock direction to remove
the caps. Clean the caps and reinstall
them in the indicated lock direction.
4. Clean caps and remove
entagled hair before
reinstalling in the indicated
lock direction.
Notes:
• Main brush should be wiped down with wet cloth and left to dry away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to clean the main brush.
5. Reinstall the main brush cover, making
sure that the four teeth are fully seated
in the slots before pressing the main
brush cover.
Side Brush
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the
screw.
1. Use a tool, such as a small
screwdriver, to pry out
the axle and take out the
wheel.
Omni-Directional Wheel
Note: The omni-directional wheel bracket cannot be removed.
2. Rinse the wheel and the axle with water to
remove any hair and dirt.
3. Air-dry, reinstall, and press the wheel and axle back in place.