Roborock G10 - Assembly and Placement; Powering On and Charging

Installation
Assembly
1. Place the dock on a hard and flat
surface, and remove the foam
used to secure the high-speed
maintenance brush components in
shipment at the bottom.
2. Attach the base by pressing down
both sides of the base firmly, and then
pressing the connecting part in the
middle until you hear a click.
3. Connect the power cable to the back
of the dock, and keep excess cable
inside the storage slot.
Step 1
Step 1
Step 2
Power cable can be pulled out at both sides.Note:
> 0.5 m (1.6 ft)
> 0.5 m (1.6 ft)
> 1 m (3.3 ft)
> 1.5 m (4.9 ft)
Placement of the Dock
Place the dock on a hard and flat floor (wood/tile/concrete etc.),
flat against a wall. Keep at least 0.5 m (1.6 ft) of clearance on
either side, 1.5 m (4.9 ft) in front, and 1 m (3 ft) above. Check the
location has good WiFi for a better experience with the mobile
app, and then plug it in.
Notes:
• If the power cable hangs vertically to the ground, it may be caught by the robot, causing
the dock to be moved or disconnected.
• The dock indicator is on when the dock is powered on, and off when the robot is charging.
• The dock indicator turns red if an error occurs.
• Place the dock on a flat floor away from fire, heat, and water. Avoid narrow spaces or
locations where the robot may be suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may cause the dock to tilt over and cause
problems docking and departing.
• Keep the dock away from direct sunlight or anything that may block the dock location
beacon; otherwise, the robot may fail to return to the dock.
• Do not use the dock without clean water tank, dirty water tank, high-speed maintenance
brush, or water filter.
• Maintain the dock according to the maintenance instructions. Do not clean the dock with
a wet cloth or tissue.
• All docks are subject to water-based tests before leaving the factory. It is normal that a
small amount of water remains in the waterway of the dock.
Powering On & Charging
Press and hold the button to power
on the robot. When the power light
goes on, place the robot on the dock
to charge. Make sure the charging
dock power indicator turns off and
a “charging" voice alert sounds. To
maintain the performance of the high-
performance lithium-ion rechargeable
battery pack, keep the robot charged.
Note: The robot may not be turned on when the battery is low. In this case, connect the
robot to the dock.
Power
Indicator
Breathing:
Charging