Robustel GoRugged R2000 Dual - Reset Button; Ethernet Ports; Insert or Remove SIM Card

Robustel GoRugged R2000 Dual User Guide
RT_UG_R2000 Dual_v.1.0.5 25 April, 2017 16/116
Confidential
2.3 Reset Button
2.4 Ethernet Ports
R2000 Dual Router has five Ethernet ports. Eth0 is a WAN port and Eth1~Eth4 are LAN ports supporting POE feature.
Every Ethernet port has two LED indicators, while each indicator has three states. The yellow one is Link Indicator
and the green one doesn’t mean anything. For details see the table below.
Indicator
State
Description
Link Indicator
On
Connection is working
On, blinking
Data is being transmitted
Off
Connection is not working
2.5 Insert or Remove SIM Card
 Insert SIM Card
1. Make sure the router is powered off.
2. To remove slot cover, loosen the screws associated with the cover by using a screwdriver and then find the SIM
card slot.
3. To insert SIM card, press the card with fingers until snap on and then tighten the screws associated with the
cover by using a screwdriver.
Function
Operation
Reboot
Press and hold the Reset button for at least 2~7 seconds under the operating status.
Restore to factory
default settings
Wait for 5 seconds after powering up the router, press and hold the Reset button by a
small non-conductive stick with a blunt end until all twelve LEDs blinking one by one, and
release the button within 5 second to return the router to factory defaults.