Robustel GoRugged R2000 Dual User Guide
RT_UG_R2000 Dual_v.1.0.5 25 April, 2017 17/116
Confidential
Remove SIM Card
1. Make sure the router is powered off.
2. To remove SIM card, press the card with fingers until pop out and then take out the SIM card.
3. Put back the slot cover and tighten the screws associated with the cover by using a screwdriver.
Note:
1. Recommended torque for inserting is 0.5 N.m, and the maximum allowed is 0.7 N.m.
2. Use the specific M2M SIM card when the device is working in extreme temperature (temperature exceeding
0-40℃), because the regular SIM card for long-time working in harsh environment (temperature exceeding
0-40℃) will be disconnected frequently.
3. Do not forget to twist the cover tightly to avoid being stolen.
4. Do not touch the metal of the SIM card surface in case information in the card will lost or be destroyed.
5. Do not bend or scratch the SIM card.
6. Keep the SIM card away from electricity and magnetism.
7. Make sure router is powered off before inserting or removing the SIM card.
2.6 Attach External Antenna (SMA Type)
Connect the SMA external antenna connector to the router’s antenna interface and twist tightly.
Make sure the antenna is within the correct frequency range provided by the operator and with 50 Ohm impedance.
Note: Recommended torque for mounting is 0.35 N.m.
2.7 Mount the Router
The R2000 Dual Router supports flat surface placement, wall mounting and DIN rail mounting.
(unit: mm)
To Next Page
Loading...
