Robustel GoRugged R2000 Dual User Guide
RT_UG_R2000 Dual_v.1.0.5 25 April, 2017 52/116
Confidential
WiFi Client
Configure R2000 Dual as a WiFi client
R2000 Dual Router support both WiFi AP and WiFi client. The factory default setting of R2000 Dual is as WiFi AP.
This section allow user to configure the R2000 Dual Router as a WiFi client and set the related parameters.
Go to WiFi tab, select the WiFi mode as Client, click “Submit”;
Go to the 3.6 Link Manager > WLAN tab Configure the WiFi AP parameters, and the way of configuration refer to the
3.6 Interface > Link Manager Section. Please remember to click “Save&Apply” and “reboot” after finish the
configuration, so that the configuration can be effective.
After configure R2000 Dual as WiFi Client successfully, a WLAN page will be generated under the “Interface” tab. Go
to Interface > WLAN check the WLAN connection status. It includes WLAN status, Link status and WPA status.
To Next Page
Loading...
