Robustel GoRugged R2000 Dual User Guide
RT_UG_R2000 Dual_v.1.0.5 25 April, 2017 43/116
Confidential
Click button, configure the port setting.
The index of Ethernet port, cannot edit.
Select from ETH1 to ETH4.
Note: Only ETH0 can be assigned as wan. One of ETH1~ETH4 port should be assigned
to lan0 a least.
Select from wan, lan0, lan1, lan2 and lan3.
Note: Only ETH0 can be assigned as wan. Lan0~lan3 is available when they were
selected randomly by ETH1~ETH4 in 3.8 Interface > Ethernet section. All of
ETH1~ETH4 port can be assigned as the same lan. All of ETH1~ETH4 default to lan0,
and the default IP is 192.168.0.1/255.255.255.0.
Click to enable or disable the POE function. When enable POE function and connect
POE voltage, R2000 dual can supply power to the behind device via ETH1~ETH4.
Note: ETH0 cannot support POE function.
This section shows the link connection status of all the Ethernet port.
To Next Page
Loading...
