Roca BCH-7 - Fan Settings & Day;Night Selection

23
temperature, this is the minimum differential allowed by
the thermostat. Press the MODE button repeatedly until
the heating symbol and cooling symbol are displayed
on the panel (at the same time the word will be
displayed for 5 seconds). The heating and cooling symbols
will continue to be displayed on the panel.
After a few minutes have passed the system will start up,
automatically switching to the heating or cooling mode
and maintaining the temperature between the selected
margins. The symbol corresponding to the operational
mode, heating or cooling, will start to flash.
d) Emergency heating
Repeatedly press the MODE button until the letters
(displayed for 5 seconds) appears on the display panel, at
the same time the heating symbol will be displayed;
once a few minutes have passed the emergency heating
will start up, and the heating symbol will start to flash.
In this operational mode the compressor is always shut
down and the (optional) auxiliary and emergency resistance
heaters, if they are fitted, are used to supply the heat.
This operational mode can also be used for heating in
case of a compressor breakdown.
e) Off
Repeatedly press the MODE button until the word
appears on the display. The heat pump will stop and on
the thermostat display panel the word and the
ambient temperature will be permanently displayed.
3.- Day/night selection
Different set temperatures can be selected by pressing the
DAY/NIGHT button, for day and night (in each of the
f) °C/°F scale
To change the scale of degress of temperature, press the
and buttons simultaneously.
2.- Fan
The Fan is started up in a continuous manner by pressing the
FAN button (independently of the operational state of the
unit), the fan and air-flow symbols will be displayed on the
thermostat display panel, the fan symbol steadily and the flow
symbol flashing.
The FAN symbol will disappear when the button is
pressed again and the fan will be automatically controlled in
unison with the compressor or the electrical resistance heater
(should this be installed).
SELECTED MODE
(DISPLAYED FOR 5 SECONDS)
AMBIENT TEMPERATURE
HEATING SYMBOL
SELECTED MODE
COOLING SYMBOL
SELECTED MODE
(DISPLAYED FOR 5 SECONDS)
AMBIENT TEMPERATURE
HEATING SYMBOL
DISPLAY PANEL WHEN
THE SYSTEM HAS BEEN
COMPLETELY SHUT DOWN
AIR-FLOW SYMBOL
(FLASHING DISPLAY)
DISPLAY PANEL WHEN THE
FAN IS CONTINUALLY
OPERATIONAL
FAN SYMBOL
(CONSTANTLY DISPLAYED)