User’s Manual
Installation guide
Guarantee card Remote unit
Mounting Plate with
Hardware kits
T-valve with Bidet Hose
(60cm)
Parts list
Battery x4
5
English
Specification
Power Source
220-240V~, 50/60Hz
Maximum Power Consumption 1300W
IP Rating IPX4
Front and rear cleaning
Tap water pressure (connect to cold water) 0.1~0.7 MPa (100-700KPa)
Rear spray volume
0.2~0.8 l/min
Front spray volume 0.2~0.8 l/min
Maximum heater capacity 1200W
Heating system
Instant water heating
Water temperature Off / 35 °C / 37 °C / 39°C
Safety device Thermal Fuse
Dryer
Warm dryer temperature 40~60 °C
Maximum heater capacity 350W
Air dryer speed 12 m/s
Safety device Thermal Fuse
Seat
Heated seat surface temperature Off / 35˚C / 37˚C / 39˚ C
Heater capacity 40W
Safety device Thermal Fuse
Deodorizer Active carbon, Volume 0.1m
3
/min
Night light Led
Power saving
Length of power cord 120cm
Product weight Approx. 5 kg)
Above specifications have been measured under room temperature of 25°C, incoming water temperature between 15°C and 30°C
and Water pressure of 0.2MPa. Incoming water temperature out of this range can cause unstable temperature of the water coming
out through the nozzle.
Themanufacturer reserves the rightto change above specifications at any time without notice and without incurring obligations.
Dual check valve must be fitted after the cistern stop.
Please note that this product has an Integral High Hazard Backflow Prevention device which complies with the requirements of
AS 2845.2:2010
Caution for mild burn
Please adjust the seat and water temperature at the lowest level if the product is to be used by :
1. Children, elderly people or sick patients
2. People with skin allergies.
3. People taking medication (sleeping pill, medicine for cold…, etc) which might cause drowsiness or tiredness.
Please use lower temperature ( 35°C) in order to prevent mild burns occurring while using this product when sitting same position
with a skin contacting seat.
Please refer to "Seat heater" in the manual for operation instructions.