12
Placing the sender and receiver
To avoid risk of electric shock and fire, and to prevent damage, locate
the sender and receiver units with no obstructions in front. The
receiver can be placed horizontally on a level surface, vertically in the
holder (provided), or mounted on a wall, using the mounting holes
on the bottom.
Warning:
This stand is intended for the RF-WHTIB receiver only. Use with other equipment can
result in instability and may cause injury.
Note:
If you need to mount the receiver on a wall, install it against the wall so that cool air
can travel through the ventilation slots in the unit and come out the top.
To Next Page
Loading...
Need help?
General
