9Bluetooth Indoor/Outdoor Speaker | RF-WSP313
Charging the built-in battery
This wireless speaker has a built-in Lithium Ion battery to give you
battery playback when you can’t use the AC adapter. When the AC
adapter is plugged in, the system charges. While charging, the
battery indicator lights amber. When fully charged, it turns green.
After five minutes, if you don’t turn on the speaker, the indicator turns
off and the speaker turns off.
When operating the system in battery mode, the battery indicator
blinks red when the battery is low. If you don’t charge the battery
within ten minutes, the speaker turns off. The battery takes about
four to five hours to fully charge.
Note: The battery cannot be replaced by the user.
Warning: Do not dispose of this speaker in fire. The battery may explode or leak.
Selecting a sound source
This system lets you listen to either AUX IN (wired) or Bluetooth
(wireless) sound sources. The speaker is in Bluetooth mode unless an
audio cable is connected.
If you insert an audio cable while in Bluetooth mode, the wireless
speaker automatically switches to AUX IN mode.
To resume the Bluetooth playback, remove the audio cable from the
AUX IN jack, and press the Play button on your Bluetooth device.
Using your Bluetooth Indoor/Outdoor
speaker
Turning your wireless speaker on or off
To turn your wireless speaker on or off:
1 Press the (On/Off/Pairing) button to turn it on. The speaker
takes approximately four seconds to power up. During this time,
the Power/Pairing indicator blinks red.
2 Press again to turn it off.
RF-WSP313_13-0633_MAN_V1_ENG.fm Page 9 Friday, August 9, 2013 2:02 PM
To Next Page
Loading...
Need help?
General
