Need help?Do you have a question about the Rockford Fosgate Punch 150HD and is the answer not in the manual?
General| RMS Power at 4 Ohms | 75W x 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| THD at Rated Power | <0.05% |
| Signal to Noise Ratio | > 100 dB |
| Input Sensitivity | 200 mV - 4 V |
| Crossover Frequency | 50 Hz - 250 Hz |
| Crossover Slope | 12 dB/octave |
| Fuse Rating | 30A |
| RMS Power at 2 Ohms | 150 Watts x 2 |
| Bridged RMS Power at 4 Ohms | 300 Watts |
| Bass Boost | 0 - 18dB @ 45Hz |
Advises on protecting hearing from high sound pressure levels.
Introduces the Punch amplifiers, their equalizer, and input connection methods.
Covers adjusting input sensitivity and proper power/ground wiring.
Details remote turn-on connection, speaker wiring, and wire gauge recommendations.
Explains speaker impedance, bridging mode, and speaker protection fuses.
Discusses crossover loading and lists amplifier power output ratings.
Provides a diagram for typical speaker wiring setups.
Details protection circuits, mounting guidelines, and battery system impact.
Lists power ratings, protection, and dimensions for the Punch 30.
Lists power ratings, equalization, protection, and dimensions for the Punch 45.
Lists power ratings, equalization, protection, and dimensions for the Punch 75.
Lists power ratings, equalization, protection, and dimensions for the Punch 150.
To Next Page