18
SETUP, Page 5 of 10 - Naming MIDI Channels
The fifth page of the SETUP program allows for custom 4 character
abbreviations to be shown in place of MIDI channels and instant access switches
during editing. Assigning a name to each MIDI channel can make it considerably
easier to remember which MIDI devices are assigned to particular MIDI channels.
This is also true of instant access switches.
To assign a name to a MIDI channel or instant access switch:
() With the 2ND L.E.D. still lit, press the "ð" switch to access the fifth page of
the SETUP program. (If the All Access is not already in SETUP mode, press
"2ND", then "SETUP", followed by "ð" four times.)
() To select a MIDI channel or switch to name, use the "INC" and "DEC"
switches directly below the currently selected MIDI channel/switch to
scroll through the available selections.
() Use the "INC" and "DEC" switches directly below the center of the display
to select the desired character for the current position.
() Use the "INC" and "DEC" switches directly below the right side of the
display to advance to the next character position to edit.
To Next Page
