Rocktron ALL ACCESS - SYSX, Page 3 of 3 - Byte Value Assignment

70
SYSX, Page 3 of 3 - Byte Value Assignment
The third page of the SYSX program allows for the assignment of byte values
for each byte of the system exclusive message.
() With the 2ND L.E.D. still lit, press the "ð" button to access the third page
of the SYSX program. (If the All Access is not already in the SYSX editing
mode, press "2ND", then "SYSX", followed by "ð" two times.)
To assign values to the MIDI string bytes:
() Use the "INC" and "DEC" switches directly below the currently displayed
byte number to select the desired byte to assign a byte value to.
() Use the "INC" and "DEC" switches directly below the current byte value
displayed to select the value to assign to the displayed byte number.
() An "EOX" (End of Exclusive) value ends the MIDI string and does not allow
any following bytes to be programmed.