42
MIDI, Page 7 of 7 - MIDI Receive Channel
The seventh page of the MIDI program, MIDI Receive Channel, determines
the MIDI channel that incoming program changes must be on for the All Access
to respond. (This feature is operable only in Bank Mode - see SETUP, Page 1).
To define the MIDI receive channel:
() With the 2ND L.E.D. still lit, press the "ð" switch to access the next page
of the MIDI program, MIDI Receive Channel. (If the All Access is not
already in the MIDI editing mode, press "2ND", then "MIDI", followed by
"ð" six times.)
() Use the "INC" and "DEC" switches directly below the displayed MIDI
Receive channel to select the MIDI channel that the All Access is to
receive MIDI commands on.
To Next Page
Loading...
