Rocktron ALL ACCESS - MIDI, Page 6 of 7 - Program Mapping

40
MIDI, Page 6 of 7 - Program Mapping
This page allows for incoming program changes to be mapped to All
Access presets when the Program Change Status is set to "MAP" (see MIDI,
Page5). This feature is only available when operating the All Access in Bank
Mode.
To assign the program mapping status:
() With the 2ND L.E.D. still lit, press the "ð" switch to access the next page
of the MIDI program, Program Mapping. (If the All Access is not already
in the MIDI editing mode, press "2ND", then "MIDI", followed by "ð" five
times.)
() Use the "INC" and "DEC" switches directly below the displayed Program
Change number to select the desired Program Change number to be
mapped to an All Access preset.
() Use the "INC" and "DEC" switches directly below the displayed preset
number to select the All Access preset that the displayed program change
number will be mapped to.