72 Rockwell Automation Publication 750-TG100B-EN-P - June 2019
Chapter 4 Frame 5 Components
Install the LCL Filter Capacitor
Follow these steps to install a replacement LCL filter capacitor.
1. Inspect the foam pad on the side wall of the chassis for damage.
2. If the pad is damaged, remove the existing pad material.
3. Clean the surface of the chassis with a 50% isopropyl alcohol and 50%
water solution and install the new foam pad that is provided with the kit.
4. Insert all three legs of the resistor that is supplied with the kit into the
terminal block at the top of the capacitor and secure the resistor.
4
4
M5
3 mm
1.8 N
•m (16.0 lb•in)
To Next Page
Loading...
Need help?
General
