Rockwell Automation Publication 750-QS100B-EN-P - August 2020 5
Preface
Introduction
This Quick Start is designed to guide you through the basic steps that are required to start up your PowerFlex® 755TL
low harmonic, or PowerFlex 755TR regenerative standalone AC drives, for the first time, for simple applications. This
procedure uses the Human Interface Module (HIM) to configure parameters. However, you can use Connected
Components Workbench™ (CCW) (version 11 or later) software and the associated PowerFlex 755T Wizards to
configure parameters, instead of using the HIM.
Who Should Use This Manual
This manual is intended for qualified personnel.
• You must understand the hazards that are associated with electromechanical equipment installations.
• You must understand and follow all applicable local, national, and/or international electrical codes.
• You must be able to program and operate Adjustable Frequency AC Drive devices.
• You must have an understanding of the parameter settings and functions.
Equipment
The following equipment requirements apply to the use of this publication:
• The drive is a PowerFlex 755TL or PowerFlex 755TR standalone installation.
• The motor is either an induction motor, a synchronous reluctance motor, or a permanent magnet motor.
• No load sharing or multiple motors on a single drive.
• The drive has all required circuit protection installed.
• The drive and motor are connected and ready to have AC power applied.
• The drive is equipped with either a PowerFlex 20-HIM-A6 or a 20-HIM-C6S Human Interface Module (HIM).
• If used, the motor feedback device is a quadrature (AqB) incremental encoder.
Supported Applications
This publication is intended for use on simple velocity control applications with fans, pumps, compressors, and
conveyors.
To Next Page
Loading...
Need help?
General
