Publication 1771-6.5.132 - June 2000
A-2 1785-ENET Module Channel Configuration
2. Select the Channel 3A tab.
3. Select Ethernet as the Channel Type.
4. Uncheck the BOOTP Enabled box to disable BOOTP.
5. Enter the IP Address you want to assign to the PLC-5 processor
(e.g., 130.130.130.2).
6. Download the configuration to the processor, using a
communications driver that was previously configured, (e.g,
ControlNet or DH+). See chapter 6 for examples of downloading
to the PLC-5 using these drivers.
To Next Page
Loading...
