Need help?Do you have a question about the Rockwell Automation Allen-Bradley 1715-IF16 and is the answer not in the manual?
General| Product Type | Analog Input Module |
|---|---|
| Number of Channels/Inputs | 16 |
| Resolution | 16-bit |
| Input Type | Voltage, Current |
| Input Range | 0-10V, 0-20mA, 4-20mA |
| Operating Temperature | 0 to 60 °C |
| Storage Temperature | -40…85 °C (-40…185 °F) |
| Isolation Voltage | 1500V RMS |
| Relative Humidity | 5% to 95% (non-condensing) |
| Enclosure | Open |
Provides essential safety and operational guidelines for product installation and use.
Lists and describes the physical components that constitute the redundant I/O system.
Guides on creating a new project and configuring the controller in the development environment.
Explains how to add and configure the redundant adapter pair within the project's I/O configuration.
Outlines necessary firmware, Add-on Profiles, and controller requirements for SIL 2 applications.
Details the use of 1715 I/O modules in SIL 2 safety applications, including configuration options.
Provides steps to enable and configure SIL 2 operation for modules, including RPI and CRTL settings.
Introduces SIL 2 Add-On Instructions for verifying data integrity between controller and I/O modules.
Guides on obtaining and importing SIL 2 Add-On Instructions into the project.
Explains creating a dedicated, high-priority periodic task for SIL 2 safety logic.
Describes indications and causes for system-wide faults affecting adapters or modules.
Explains how hardware faults specific to a module are indicated on the module and adapter.
Describes calculating and setting threshold values for accurate digital input diagnostics.
Provides methods to calculate threshold and resistor values for diagnostic configuration.
A checklist for planning, programming, and startup of SIL 2-certified systems using 1715 I/O modules.
To Next Page