Need help?Do you have a question about the Rockwell Automation Allen-Bradley 1794-IB16D and is the answer not in the manual?
General| Manufacturer | Rockwell Automation |
|---|---|
| Product Type | Digital Input Module |
| Number of Inputs | 16 |
| Input Voltage Category | 24V DC |
| Series | 1794 |
| Input Type | Sinking |
| Operating Voltage | 10 to 30 VDC |
| Isolation Voltage | 500V AC |
| Module Type | Digital Input |
| Operating Temperature | -20 to 60 °C |
| Storage Temperature | -40 to 85°C (-40 to 185°F) |
| Relative Humidity | 5...95% noncondensing |
| Compatibility | FLEX I/O system |
Covers critical safety, environmental, and installation precautions, including hazardous location information.
Details approvals and safety requirements for operating equipment in hazardous locations.
Provides steps for installing digital input or output modules and terminal bases.
Details detection of open circuits and short circuits in sensor power.
Covers detection of reverse polarity in the user power supply.
Guides on configuring the diagnostic input module and input filter times.
Explains fault monitoring for output channels and user supply.
Details protection mechanisms against output shorts and overcurrents.
Covers detection of reverse polarity in the external user power supply.
Guides on configuring the diagnostic output module.
Steps to add a 1756-DHRIO module to RSLogix 5000 project.
Steps to add a 1794-ASB adapter to the project.
Steps to create message instructions for block transfers.
Guides adding the scanner to the controller's I/O configuration.
Steps to add the scanner to the RSLogix 5000 I/O configuration folder.
Explains how to determine tag names for DeviceNet data.
Procedures for setting the address of the FLEX I/O DeviceNet adapter.
Steps to add ControlNet communication modules and adapters.
Procedures for scheduling I/O module connections using RSNetWorx.
Guides on adding bridge, adapter, and I/O modules for EtherNet/IP.
Procedure for downloading the project to the controller.
Provides overview of IP addresses, subnet masks, and gateways.
Provides overview of IP addresses, subnet masks, and gateways.
Guides on using BOOTP/DHCP utility for parameter assignment.
Steps to set IP address using RSLinx software.
Steps to set IP address using RSLogix 5000 software.
Guides on setting IP address using DHCP software.
Provides detailed functional information for the 1794-IB16D module.
To Next Page