Safety
Electrical Hazards
24 MagneMotion
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Electrical Hazards
The MagneMover LITE components are classified as low voltage devices, no additional
safety precautions are required.
The power supplies, node controllers, network switches, and power modules are connected to
the AC Mains of the facility and can generate hazardous energy. The proper precautions for
operating and servicing electrical equipment must be observed. These precautions include fol-
lowing facility lockout/tagout procedures, and any other specified action within the facility
where the MM LITE components are being used.
WARNING
Electrical Hazard
All electrical power to the MagneMover LITE transport sys-
tem must be disconnected per the facility’s lockout/tagout
procedure before servicing to prevent the risk of electrical
shock.
CAUTION
Electrical Hazard
To avoid electric shock, do not open any MagneMover LITE
component. Motors, controllers, and other components do
not contain any user-serviceable parts.
Do not turn on electrical power to the power supplies,
motors, and Node Controllers until after connecting all other
transport system components.
NOTICE
To avoid equipment damage:
• Make sure that the transport system is properly grounded.
• When using custom vehicles or user-supplied rails, make sure that all
vehicles are grounded to the guideway through conductive wheels or
static brushes.
• Do not connect or disconnect any components while the transport sys-
tem has power.
To Next Page
Loading...
Need help?
General
