What to do if single puck Rockwell Automation MagneMotion MagneMover LITE vehicle with a large offset payload gets stuck in a switch?
If a single puck vehicle with a large offset payload gets stuck in a switch or takes the wrong path, it may be due to the large offset payload affecting vehicle motion through a standard switch. To resolve this, minimize the size of the offset payload or replace the standard switch with a high-payload switch.
Why do Rockwell Automation MagneMotion MagneMover LITE vehicles in curves report ‘Hindered’ after startup?
Vehicles may report ‘Hindered’ when attempting to move them after startup because they were moved manually before the system startup. For switches, leave one vehicle in place and move all other vehicles out of the Node Clearance Distance and Entry Gate positions. For curves, leave one vehicle in place and move all other vehicles out of the curve.
How to prevent Rockwell Automation MagneMotion MagneMover LITE vehicles on tandem pucks from colliding in curves?
If vehicles on tandem pucks collide with other vehicles in curves, it's because a wide vehicle on a tandem puck has a smaller radius of motion in a curve than the physical curve. You can resolve this by defining the vehicle larger than its actual size.
General| Brand | Rockwell Automation |
|---|---|
| Model | MagneMotion MagneMover LITE |
| Category | Accessories |
| Language | English |
To Next Page
