MagneMover LITE User Manual Addendum,
Wide Vehicles
MMI-UM034B-EN-P Page 29 of 31
Troubleshooting
This section briefly identifies common difficulties that can occur with vehicles using the
wide vehicle option.
Table 1 Troubleshooting
Vehicles in curves or
switches report ‘Hindered’
when attempting to move
them after startup.
Vehicles were moved
manually before system
startup.
For switches, leave one
vehicle in place and move
all other vehicles out of the
Node Clearance Distance
and Entry Gate positions.
For curves, leave one
vehicle in place and move
all other vehicles out of the
curve.
Vehicles on tandem pucks
collide with other vehicles in
curves.
Wide vehicle on tandem
puck has a smaller radius of
motion in a curve than the
physical curve.
Define the vehicle larger
than actual size.
Single puck vehicle with a
large offset payload gets
stuck in a switch or takes
the wrong path through a
switch.
affect vehicle motion through
a standard switch.
offset payload.
Replace the standard
switch with a high-payload
switch.