To Next PageTo Next Page
Need help?Do you have a question about the ROCON DeltaPoint Jr and is the answer not in the manual?
Provides a top view diagram of the DeltaPoint Jr. unit with key dimensions and port labels.
Presents an end view diagram of the DeltaPoint Jr. unit, detailing its physical dimensions.
Guides users on how to set the flowmeter to display units in GPM or LPM.
Instructions on how to set the alarm setpoint for the flowmeter output.
Steps to verify the unit operates correctly with initial water flow.
Procedure to test flow fault detection when a weld gun arm cap is removed.
Verifies the unit's response to low or shut-off water flow conditions.
Checks the unit's ability to restart remotely after a shutdown.
Steps to diagnose and resolve issues where the unit fails to power on.
Troubleshooting guide for when the unit fails to initiate operation, covering insufficient flow.
Addresses the issue of continuous water flow when a cap is removed from the weld gun.
Solutions for problems preventing the unit from restarting after a stop.
Diagnoses causes for an unstable or fluctuating display on the flowmeter.
Troubleshooting steps when the solenoid valve fails to open.
Guides on resolving issues where the fault alarm signal is not transmitted to the controller.
Instructions for inspecting and replacing the flowmeter's bluff assembly.
Procedure for replacing the solenoid valve coil.
Steps to clean the diaphragm orifice and plunger pilot hole of the shut-off valve.
Addresses the issue of a broken override stem on the shut-off valve.
Guide for inspecting and removing the piston from the check valve.
Recommendations for cleaning the external surfaces of the meter.
Detailed mechanical and electrical specifications for the DeltaPoint Jr. unit.
Specific technical details and operating parameters for the check valve.
Technical details and operating parameters for the shut-off valve.
General| Brand | ROCON |
|---|---|
| Model | DeltaPoint Jr |
| Category | Industrial Equipment |
| Language | English |
