5. Rotate the Alpha Dial to select the desired velocity value (“LIGHT”, “NORMAL”
or “HEAVY”).
6. Press either the flashing MIDI coupler piston or General Cancel to exit. Note: A
MIDI Save may be performed to save this setting as the default. Please refer to the
“MIDI Save” section.
The MIDI Note Velocity can be individually set for each MIDI coupler piston. Note:
The MIDI Note Velocity settings do not affect the sampled organ voices
OCTAVE SHIFT
Normally all MIDI coupler pistons play at standard pitch (middle C = note 60). The
Octave Shift setting can be set to cause any MIDI piston to play one or two octaves above or
below standard pitch.
SHIFTING THE OCTAVE OF A MIDI SOUND:
1. Hold the SET piston, and press the MIDI coupler piston.
2. Turn the Select Knob clockwise (right) until the cursor moves to “NORM” on the
second MIDI menu screen.
3. Rotate the Alpha Dial to the desired setting (“UP 2”, “UP 1”, “NORM”, “DN 1” or
“DN 2”).
4. Press either the flashing MIDI coupler piston or General Cancel to exit. Note: A
MIDI Save may be performed to save this setting as the default. Please refer to the
“MIDI Save” section.
MIDI CHANNEL ASSIGNMENT
Using the Rodgers 835 as a MIDI keyboard controller for sequencing may require channel
assignment of the MIDI GT A coupler piston. All other MIDI coupler pistons transmit on
fixed channels. To reset the transmit channel of MIDI GT A, perform the following
procedure:
ASSIGNING MIDI CHANNELS:
1. Hold the SET piston, then press MIDI GT A. The coupler piston flashes.
2. Turn the Select Knob clockwise (right) until the cursor moves to the channel
number.
3. Rotate the Alpha Dial to set the channel number.
4. Press either the flashing MIDI coupler piston or General Cancel to exit.
The channel number for MIDI GT A coupler piston can be saved in the settings on a
combination piston or saved permanently by performing the MIDI Save procedure. Note: A
MIDI Save may be performed to save this setting as the default. Please refer to the “MIDI
Save” section.
To Next Page
Loading...
