Appendix
115
[MIDI] Parameters
These parameters allow you to set MIDI functions when external MIDI devices are being used. Press the
[MIDI] button in the desired section (UPPER, LOWER or BASS) to access these parameters:
Upper/Lower/Bass MIDI
Port: 1, 2
This parameter allows you to select the MIDI OUT port to be used for data transmission. Use the [+] and [-]
buttons to select the port.
Channel: 1-16
This parameter allows you to select the channel on which MIDI data will be transmitted. Press the [NEXT]
button to select this parameter. Use the [+] and [-] buttons to set the MIDI channel.
Prg: 0-128 Bnk: 0-127
The first parameter allows you to determine which Program Number will be transmitted. Press the [NEXT]
button to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the Program Number. Press the
[NEXT] button to select the Bank (Bnk) parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the Bank
Number. (A Prg or Bnk Number of '0' means that no Program Change or Bank select messages are
transmitted.)
Bnk LSB: 0-127
This parameter allows you to determine which LSB Bank (Control Change 32) will be transmitted. Press the
[NEXT] button to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the Bank LSB
Number.
Transpose: -127-127
This parameter allows you to set the amount of pitch transposition in the MIDI data. Press the [NEXT]
button to select this parameter. Use the [+]/[-] (or [++]/[--]) buttons to make the transposition setting.
Min Note: C0-G10
This parameter allows you to determine the lowest note number in the active range. Use the [+]/[-] (or
[++]/[--]) buttons to set the minimum note number.
Max Note: C0-G10
This parameter allows you to determine the highest note number in the active range. Use the [+]/[-] (or
[++]/[--]) buttons to set the highest note number.
Volume: 0-127
This parameter allows you to set the volume of transmitted MIDI data. Press the [NEXT] button to select this
parameter. Use the [+]/[-] (or [++]/[--]) buttons to set the volume.
Rev: 0-127
This parameter allows you to determine the reverb level. Use the [++] and [--] buttons to set the reverb level.
Cho: 0-127
This parameter allows you to determine the chorus level. Use the [++] and [--] buttons to set the chorus level.
To Next Page