79 Courtesy light time
0 → OFF
1 → IMPULSIVE, the output is on for a short time when it starts the movement
2 → the output is on during all movement time
3-90 → SECONDS after the end of the movement, in which the output is on and moreover it is on during all
movement time
92-99 → from 92 the second number indicates the MINUTES after the end of the movement, in which the
output is on and moreover it is on during all movement time (from 2 to 9 minutes)
2
8A Configuration clock input (ORO), closing the contact it causes an opening of the gate, while the opening
of the contacts causes the closing of the gate. You can choice 2 configurations:
0 → When the clock input (ORO) is closed, it ignores all inputs
1 → When the clock input (ORO) is closed, it accepts all inputs
0
90 Recover setting default
To recover all parameters setted on Roger Technology (look the last column of this table), You have to push
the selection button and after the 2 scrolling buttons togheter. If this process is done in the correct way the
display shows You the parameter LL..
n0 Serial number
00-FF → control unit model
n1 Serial number
00-99 → production year
n2 Serial number
00-52 → production week
n3 Serial number
00-99 → 1° progressive number
n4 Serial number
00-99 → 2° progressive number
n5 Serial number
00-99 → 3° progressive number
n6 Serial number
00-99 → software version
o0 Movements number
00-99 → X 10.000 movements
o1 Movements number
00-99 → X 100 movements
h0 Motor activation hours
00-99 → X 100 hours
h1 Motor activation hours
00-99 → hours
d0 Power on in days of control unit
00-99 → X 100 days
d1 Power on in days of control unit
00-99 → days
P1 Password P1
00-99
00
P2 Password P2
00-99
00
P3 Password P3
00-99
00
P4 Password P4
00-99
00
CP Change password
To change the password, You have to insert the old one to deblock the control unit. After we insert the new
one, we select the paramenter CP (change password), we push the button S3 (00 flashing) and finally we
have to push togheter the buttons S1 and S2. On the beginning the password setted is 00 00 00 00. If You
lose the password, You can deblock the control unit contacting the service.
15
To Next Page
Loading...
Need help?
General
