R&S FSH Interference Analyzer (R&S FSH-K15/ -K16)
Working with Maps
Operating Manual 1173.6275.12 - 30 160
1 Current type of result display
2 Connected device: green color = GPS connection established, red color GPS connection not established
3 Hardware settings
4 GPS information, incl compass information, GPS connection quality and triangulation results (not in
R&S FSH-K17)
5 Power results (incl. the distance between measurement locations in the R&S FSH-K17)
6 Map area, including tags representing the measurement locations
7 Power bar including noise squelch level
8 Geotagging / Indoor Map softkey menu
Adding and removing elements
The result display is made up out of several elements that you can add or remove as
you like.
► Press the MEAS key.
► Press the "Settings" softkey.
► Select the element you want to add or remove.
- GPS receiver and antenna support
► Turn on with "Antenna", "Compass" or "GPS" menu item.
Supported by R&S FSH-K15 and -K16.
- Hardware settings
► Turn on with "Show Hardware Settings" menu item.
If on, the display contains the hardware settings.
- GPS and compass information
► Turn on with "Show GPS Information" or "Show Compass Information"
menu item.
If on, the display contains the GPS and compass information. The compass
information is available with the R&S HL300 antenna.
Supported by R&S FSH-K15 and -K16.
- Power results
► Turn on with "Show Power Results" menu item.
If on, the display contains the power results.
- Power bar
► Turn on with "Show Power Bar" menu item.
If on, the display contains the power bar.
In addition to the currently measured signal level, the power bar also shows
the squelch level for noise signals (vertical yellow line).
To Next Page
Loading...
