Rohde & Schwarz NRP-Z51 - SENSe Commands

Remote Control - Commands R&S NRP-Z5x
1137.0463.12 6.6 E-7
SENSe (Sensor Configuration)
The sensor is configured by means of the commands of the groups SENSe and TRIGger.
Table 6-2 Commands of the SENSe system
Command Parameter Unit Remarks
SENSe
:AVERage
:COUNt[?] 1 to 65536
:AUTO[?] OFF | ON | ONCE
:MTIMe[?] 0.01 to 999.99 s
:NSRatio[?] 0.0 to 1.0 dB
:RESolution[?] 1 to 4
:TYPE[?] RESolution | NSRatio
:RESet No query
:STATe[?] OFF | ON
:TCONtrol[?] MOVing | REPeat
:CORRection
:DCYCle[?] 0.001 to 99.999 %
:STATe[?] OFF | ON
:OFFSet[?] –200.0 to 200.0 dB
:STATe[?] OFF | ON
:SPDevice:STATe[?] OFF | ON
:FREQuency[?] 0.0 to 18.0e9 (NRP-Z51) or 33.0e9 (NRP-Z52) or
40.0e9 (NRP-Z55 Mod. 03) or
44.0e9 (NRP-Z55 Mod. 04)
50.0e9 (NRP-Z56) or 67.0e9 (NRP-Z57)
Hz
:FUNCtion[?] “POWer:AVG“
:POWer
:AVG
:APERture[?] 0.001 to 0.3 s
:BUFFer
:SIZE[?] 1 to 1024