Improving Level Performance
R&S
®
SMA100B
241User Manual 1178.3834.02 ─ 05
Remote command:
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:SRANge:STARt
on page 458
Max Frequency - Power Analysis
This parameter is only available for Configure Measurement > "Frequency" and Use
Separate Frequency- Power Analysis > "Active".
Sets the maximum frequency of the measurement.
Remote command:
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:SRANge:STOP
on page 458
Use as X Scale - Power Analysis
This parameter is only available for Configure Measurement > "Frequency" and Use
Separate Frequency- Power Analysis > "Active".
Activates the use of the separate frequency min and max values for the scaling of the
x-axis. Thus, the trace for this sensor is visible in the diagram , especially for frequency
ranges that differ substantially from the generator settings.
If more than one sensor is active, which use separate frequencies, the option is only
available for one sensor. To indicate the traces of the other sensors, use function "Map
to X Scale".
Remote command:
n.a.
Map to X Scale - Power Analysis
This parameter is only available for Configure Measurement > "Frequency" and Use
Separate Frequency- Power Analysis > "Active".
Maps the trace of a sensor that uses separate frequency to the current scaling of the
diagram. Usually the scale is determined by the set frequency range of the generator. If
more than one sensor is active, which use separate frequencies, the scale can also be
determined by the separate frequency range of one of the other sensors.
Remote command:
n.a.
Configure Pulse Data
For R&S NRP-Z power sensors that support time domain analysis and automatic pulse
analysis.
The power sensors enable pulse data analysis in measurement mode time. All impor-
tant pulse parameters are measured after setting the threshold levels. The following
graph shows most of these parameters:
Using Power Sensors
To Next Page
Loading...
