Rohde & Schwarz R&S SMA100B - Source:adf Subsystem

Remote Control Commands
R&S
®
SMA100B
548User Manual 1178.3834.02 ─ 05
EXT|INT,EXT
An external modulation source is used, additional to the internal
modulation source.
The external signal is input at the Ext connector.
Example: See Example "Configure and generate a VOR signal"
on page 544.
<subsystem>:SETTing:FREQuency:SYNChronize:STATe
[:SOURce<hw>]:ILS[:GS|GSLope]:FREQuency:SYNChronize[:STATe] <Mode>
[:SOURce<hw>]:ILS:LOCalizer:FREQuency:SYNChronize[:STATe] <Mode>
Activates synchronization of the ILS localizer ICAO channel with the ILS glide slope
ICAO channel.
The ILS glide slope/localizer frequency of the ICAO channel (Table 5-2) is set automat-
ically.
Parameters:
<Mode> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
13.16.2.3 SOURce:ADF Subsystem
Option: R&S SMAB-K25
The SOURce:ADF subsystem contains all commands for configuring the ADF signal.
Characteristics which are valid for all modulations and the LF output are configured in
the SOURce:LFOutput subsystem. The signal is output at the LF connector.
Commands
[:SOURce<hw>]:ADF:COMid:CODE................................................................................ 548
[:SOURce<hw>]:ADF:COMid:DASH.................................................................................549
[:SOURce<hw>]:ADF:COMid:DEPTh............................................................................... 549
[:SOURce<hw>]:ADF:COMid:DOT...................................................................................549
[:SOURce<hw>]:ADF:COMid:FREQuency........................................................................550
[:SOURce<hw>]:ADF:COMid:LETTer............................................................................... 550
[:SOURce<hw>]:ADF:COMid:PERiod...............................................................................550
[:SOURce<hw>]:ADF:COMid:SYMBol..............................................................................551
[:SOURce<hw>]:ADF:COMid:TSCHema.......................................................................... 551
[:SOURce<hw>]:ADF:COMid[:STATe]...............................................................................551
[:SOURce<hw>]:ADF:COMid:CODE <Code>
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
SOURce Subsystem