Rohde & Schwarz R&S SMA100B - UNIT Subsystem

Remote Control Commands
R&S
®
SMA100B
685User Manual 1178.3834.02 ─ 05
13.21 UNIT Subsystem
The UNIT subsystem is used to set default units for parameters if no unit is indicated in
a command. These settings are valid for the entire instrument.
Example: Setting default units for remote control
UNIT:POW V
UNIT:ANGL DEG
Sets V (volts) as unit of all power parameters, DEG (degrees) for the phase modulation
angle and KMH for the speed.
:UNIT:ANGLe.................................................................................................................685
:UNIT:POWer.................................................................................................................685
:UNIT:ANGLe <Angle>
Sets the default unit for phase modulation angle. The command affects no other
parameters, such as RF phase, or the manual control or display.
Parameters:
<Angle> DEGree | DEGRee | RADian
*RST: RADian
:UNIT:POWer <Power>
Sets the default unit for all power parameters. This setting affects the GUI, as well as
all remote control commands that determine power values.
Parameters:
<Power> V | DBUV | DBM
*RST: DBM
UNIT Subsystem