Waveform analysis
R&S
®
RTA4000
130User Manual 1335.7898.02 ─ 08
Figure 7-13: Content of a history index file
7.5 Search
7.5.1 Search conditions and results
The search functions of R&S RTA4000 can find all edges, pulse widths, peaks, or other
events in an acquisition that match the search conditions. For each search type, spe-
cific settings are available. Searches can be performed on channel, math or reference
waveforms, available sources depend on the search type.
To configure the search
1. Press the [Search] key.
2. Select the waveform that you want to search for events: "Source".
3. Select the event type that you want to find: "Search Type".
4. Configure the search conditions: "Setup".
The found events and the search conditions are shown in the result table at the bottom
of the display. The table shows the following result values: result number, time value,
and optional value depending on the search type (voltage, width).
During running acquisition, the results in the table are updated continuously, and the
events are marked at the top of the diagram by a brown triangle outline.
Search
To Next Page
Loading...
