Rohde & Schwarz RTA4004 - Page 684

Remote control commands
R&S
®
RTA4000
684User Manual 1335.7898.02 ─ 08
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
TRIGger:A:MILStd:ERRor:PARity <ErrorEnable>
Enables/disables triggering when the parity is even.
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
TRIGger:A:MILStd:ERRor:SYNC <ErrorEnable>
Enables/disables triggering when a sync impulse doesn't fulfil the technical require-
ments or when the transmission is not valid.
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
TRIGger:A:MILStd:ERRor:TIMeout <ErrorEnable>
Enables/ disables triggering when the timeout is out of the set range.
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
TRIGger:A:MILStd:FRAMe <Frame>
Parameters:
<Frame> COMMand | STATus | DATA | ALL
*RST: CST
TRIGger:A:MILStd:MCODe:CODE <ModeCode>
Sets a function for the mode code to be triggered on.
Parameters:
<ModeCode> DBControl | TSYNchronize | TSTatus | ISELftest | TSHutdown |
OTSHutdown | ITERminal | OITerminal | RESet | VECTor |
RSYNchronize | TLAStcmmand | BITWord | STSHutdown |
OSTShutdown | ANY
DBControl: dynamic bus control.
TSYNchronize: synchronize without data.
TSTatus: transmit status word.
ISELftest: initiate self-test.
Serial bus analysis