Rohde & Schwarz RTA4004 - Page 700

Remote control commands
R&S
®
RTA4000
700User Manual 1335.7898.02 ─ 08
SEARch:PROTocol:MILStd:STATus:MERRor <StatusBit>
Searches for a message error bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:STATus:SREQuest <StatusBit>
Searches for a service request bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:STATus:SUBSystem <StatusBit>
Searches for a subsystem bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:STATus:TERMinal <StatusBit>
Searches for a terminal bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:TRMode <DataDirection>
Selects the transmission mode to be searched for.
Parameters:
<DataDirection> TRANsmit | RECeive | EITHer
*RST: EITH
SEARch:PROTocol:MILStd:TTYPe <TransmissionType>
Selects the transmission type to be searched for.
Parameters:
<TransmissionType> BCRT | RTBC | RTRT | MCData
BCRT: bus controller to remote terminal transmission
RTBC: remote terminal to bus controller transmission
RTRT: remote terminal to remote terminal transmission
Serial bus analysis