Rohde & Schwarz RTA4004 - Page 712

Remote control commands
R&S
®
RTA4000
712User Manual 1335.7898.02 ─ 08
SEARch:PROTocol:ARINc:DATA:MINimum
Searches for a minimum value of the data.
The command is relevant if SEARch:PROTocol:ARINc:CONDition is set to LDATa.
Parameters:
<DataMinimum> 01X-string
SEARch:PROTocol:ARINc:DATA:OFFSet
Searches for specified data offset.
The command is relevant if SEARch:PROTocol:ARINc:CONDition is set to LDATa.
Parameters:
<DataOffset>
SEARch:PROTocol:ARINc:DATA:SIZE
Searches for specified data size.
The command is relevant if SEARch:PROTocol:ARINc:CONDition is set to LDATa.
Parameters:
<DataSize>
SEARch:PROTocol:ARINc:ERRor
Searches for an error condition.
The command is relevant if SEARch:PROTocol:ARINc:CONDition is set to ERRor.
Parameters:
<ErrorCondition> ANY | PARity | GAP | CODing
SEARch:PROTocol:ARINc:FORMat
Searches for a data format.
The command is relevant if SEARch:PROTocol:ARINc:CONDition is set to LDATa.
Parameters:
<DataFormat> DATA | DSSM | DSDI | DSSSm
SSMData: SSM+Data
SDIData: SDI+Data
SSData: SSM+Data +SDI
Serial bus analysis