Rohde & Schwarz RTM3000 Series - Page 211

Applications
R&S
®
RTM3000
211User Manual 1335.9090.02 ─ 09
Input
Selects the channel for the input signal of the DUT.
Remote command:
BPLot:INPut[:SOURce] on page 563
Output
Selects the channel for the output signal of the DUT.
Remote command:
BPLot:OUTPut[:SOURce] on page 564
Gain
Enables the gain waveform for the Bode plot.
Remote command:
BPLot:GAIN:ENABle on page 565
Phase
Enables the phase waveform for the Bode plot.
Remote command:
BPLot:PHASe:ENABle? on page 566
Run
Starts the Bode plot measurement.
Remote command:
BPLot:STATe on page 564
Repeat
Repeats the measurement, using the same parameters.
Remote command:
BPLot:REPeat on page 564
Reset
Deletes all test results.
Remote command:
BPLot:RESet on page 564
Setup
Opens the "Setup" menu to define the Bode plot settings.
Save
Saves the created Bode plot to a file. The file format is CSV.
You can find the "Save" icon in the upper right corner of the Bode plot result table, see
Figure 9-8.
Remote command:
BPLot:EXPort:NAME on page 513
BPLot:EXPort:SAVE on page 513
Bode plot (option R&S
RTM-K36)