Rohde & Schwarz Scope Rider RTH - Page 285

General Instrument Setup
R&S
®
Scope Rider RTH
285User Manual 1326.1578.02 ─ 12
Enable Touch
Switches the touch functionality of the screen on or off. Alternatively, you can press the
[SHIFT] key for 2 seconds.
In certain situations, the capacitive touchscreen can get stimulated without touching it.
Typical situations are:
●
Measuring in an environment with immissions considerably higher than specified
●
Measuring on power electronics with strong electric fields
●
Connecting the probe to power electronics DUTs with large voltages or fast rising
edges
Due to the unwanted stimulation, the R&S RTH detects three or more fingers on the
screen even though the display has not been touched. A message box informs about
the detection of more than two fingers. In this case, operate the instrument using the
keys and the wheel and disable the touchscreen.
Remote command:
DISPlay:MOUS on page 503
Selfalignment
See Chapter 13.3, "Selfalignment", on page 281.
Selftest
The self-test checks the hardware of the instrument. It is intended for service tasks.
USB/LAN
See Chapter 14.1, "LAN Connection", on page 292 and Chapter 14.2, "USB connec-
tion", on page 294.
Instrument Settings