Rohde & Schwarz Scope Rider RTH - Page 477

Remote Control Commands
R&S
®
Scope Rider RTH
477User Manual 1326.1578.02 ─ 12
BUS:SENT:PPFLength <FrameLength>
Defines a constant transmission sequence length. To select the fixed sequence length,
set BUS:SENT:PPULse to PPFL.
Parameters:
<FrameLength> Range: 104 to 922
Increment: 1
*RST: 128
BUS:SENT:PPULse
<PausePulse>
Determines if a pause pulse is part of the SENT transmission sequence.
Parameters:
<PausePulse> NPP | PP | PPFL
PP
Transmits the message with a fixed pulse length, automatically
calculated.
NPP
Transmits the SENT message without pause pulse.
PPFL
Transmits the pause pulse with a user-defined frame length to
obtain a transmission sequence with constant length.
*RST: NPP
BUS:SENT:SFORmat <Format>
Selects the serial message format.
Parameters:
<Format> NONE | SHORt | ENHanced
SHORt = Short serial message.
ENHanced = Enhanced serial message.
NONE = Single transmission sequence.
*RST: NONE
BUS:SENT:RDSL <Display>
Selects the display table view mode for the SENT protocol.
Parameters:
<Display> TRSQ | SMSG
TRSQ: fast channel
SMSG: slow channel
*RST: TRSQ
Protocol Analysis