Rohde & Schwarz SMR20 - Quick Selection of Menu (QUICK SELECT)

Basic Operating Steps R&S SMR
1134.9108.62 E-1 3.4
1-out-of-n selection  Select parameter.
 Press [SELECT] key or rotary knob.
A pop-up menu displays a selection of settings.
 Set the menu cursor to the position desired within the 1-out-of-n selection
using the rotary knob or cursor keys [] [].
 Press [SELECT] key or rotary knob.
The setting is made.
The pop-up menu is closed and the current setting is indicated at the right
margin of the display.
 Press [BACK] key or mark selection BACK using rotary knob and then press
rotary knob.
The menu cursor wraps back to the next higher menu level.
Quick Selection of Menu (QUICK SELECT)
The keys of the QUICK SELECT control field are used to call selected menus quickly by one keystroke.
Store menus  Establish the desired operating status of the current menu.
 Press [ASSIGN] key.
 Press [MENU1] or [MENU2] key.
The current menu is stored as menu1 or menu2. That is to say, 2 menus
can be stored in total.
Call menus  Press [MENU1] or [MENU2] key.
Menu1 or menu2 stored is displayed. Exactly the operating status which was
current at the point of time of storing is reconstructed.