List Editor R&S SMR
1134.9108.62 E-1 3.8
Attenuator Mode
Auto Normal setting. The mechanically switched attenuator switches in
steps of 10 dB at fixed points.
IEC/IEEE bus command :OUTP:AMOD AUTO
Fixed Level settings are made without switching the attenuator (see
section "Non-Interrupting Level Setting").
IEC/IEEE bus command :OUTP:AMOD FIX
Atten Fixed Range
Indicates the level range of non-interrupting level setting in "Attenuator Mode
Fixed".
To Next Page
Loading...
