25
Selecting and Playing Sounds
■
Selecting a Voice Using the [Others] Button
Notice that there is an [Others] button for each part of the Upper, Lower,
Solo, Pedal. By using the [Others] button, you can select all the other voices,
the ones that can’t be selected directly by pressing voice buttons.
1.
Press the [Others] button for the Part for which you wish to
specify a voice.
The voice name appears in the display.
fig.02-10 (P.29)
The indicator of the selected [Others] button will light.
For the solo part and pedal part, press the [Alternate] button and select the
voices to assign, either with the [Alternate] button ON (lit) or OFF (unlit).
2.
While the voice name is shown in the display screen, use the
Value [-] [+] buttons to select the desired voice.
The indicator of the selected [Others] button will blink.
To stop mid-way through this or any procedure, press the [Display/Exit]
button.
3.
Once again, press the [Others] button for the part whose
sound you wish to set to confirm the voice.
The indicator of the [Others] button will change from blinking to lit.
You can jump by voice
group by pressing Menu
[] [ ] buttons to
select the voice group.
The sound number of each
voice is preceded by an
alphabetical character A–T
which indicates the sound
group; e.g., “G11 Strings1.”
You can also press the key
for the part containing a
changed voice to confirm
the voice setting.
About the voices that can
be assigned to an [Others]
button, please refer to
“Voice List” (p. 102).
AT-15_e.book 25 ページ ２００５年１月２１日 金曜日 午後８時１４分
To Next Page
Loading...
