Roland EGX-20 - Table of Contents

Table of Contents
How to Use This Manual .............................................................................................................................................................. 1
To Ensure Safe Use ............................................................................................................... 3
About the Labels Axed to the AC Adapter and Unit .................................................................................................... 5
1 Getting Ready .........................................................................................................................6
What You Can Do with the EGX-20 .......................................................................................................................................... 6
Check the Included Items ........................................................................................................................................................... 6
Names and Functions .................................................................................................................................................................. 7
Setting Up and Connection ....................................................................................................................................................... 8
Attaching the Adhesive Sheet ................................................................................................................................................10
Installing the Cutter Holder .....................................................................................................................................................11
2 Installing and Setting Up the Software ..................................................................................12
The Software You Can Install and Set Up ............................................................................................................................ 12
System Requirements ................................................................................................................................................................12
Installation and Setup ................................................................................................................................................................13
3 Creating a Nameplate (Engraving Mode) ..............................................................................16
Loading Material .......................................................................................................................................................................... 16
Installing a Cutter ........................................................................................................................................................................17
Setting the Origin Point ............................................................................................................................................................19
Creating Data with Dr. Engrave ..............................................................................................................................................20
Setting the Cutting Parameters .............................................................................................................................................. 25
Performing Engraving................................................................................................................................................................27
4 Creating a Relief (3D Cutting Mode) .....................................................................................28
Removing the Cutter .................................................................................................................................................................. 28
Detaching the Depth Regulator Unit ...................................................................................................................................29
Installing a Cutter ........................................................................................................................................................................30
Loading Material .......................................................................................................................................................................... 31
Setting the Origin Point ............................................................................................................................................................32
Creating Data with 3D Engrave ..............................................................................................................................................34
Adjusting Cutting ........................................................................................................................................................................37
Performing Cutting ..................................................................................................................................................................... 38
5 More Advanced Operations ...................................................................................................39
Using Dierent Nose Cones for Dierent Purposes ........................................................................................................39
Using the 3D Cutting Mode ..................................................................................................................................................... 40
6 Optional Parts .......................................................................................................................42
Replacement Cutters and Consumable Parts....................................................................................................................42
Optional Parts for Scribing ....................................................................................................................................................... 43
7 Appendix ...............................................................................................................................44
Daily Care and Maintenance ...................................................................................................................................................44
Functions Using the Switch Panel on the EGX-20 ...........................................................................................................44
What to Do If... ..............................................................................................................................................................................45
Specications ................................................................................................................................................................................ 47
http://www.rolanddg.com/
Copyright © 2002-2012 Roland DG Corporation
Company names and product names are trademarks or registered trademarks of their respective holders.
2