(P3) Pitch Bender/Modulation and D-Beam
Go to main menu and press button 3. The display visualizes:
BendMod Db
:
(BendMod) PITCH BENDER and Modulation TEST
Pressing button 1, the display visualizes:
OFF 0
Moving the Pitch Bender lever onwards, the value changes from OFF to ON. When releasing it,
the value changes from ON to OFF.
Moving the lever all leftwards, the display visualizes –128; moving the lever all rightwards, the
display visualizes 127. Releasing the lever in central position, the display visualizes 0.
Press 0 (Exit) to go back
(Db) D-Beam Test
Press button 2 to select the D-Beam Test. The display visualizes:
0
Moving your hand vertically above the D-Beam, the value shown on the display changes from 0 to
127. When your hand is not on the D-Beam the value must be 0.
XXX
XXX= 0 to 127
Press 0 (Exit) twice to go back to the main menu.
To Next Page
Loading...
