Roland Fantom G8

182
Effects List
74: FLANGER → DELAY
* MFX only
fig.MFX-76
75: CHORUS → FLANGER
* MFX only
fig.MFX-77
76: SYMPATHETIC RESONANCE
On an acoustic piano, holding down the damper pedal allows other
strings to resonate in sympathy with the notes you play, creating
rich and spacious resonances. This effect simulates these
sympathetic resonances.
fig.MFX-78
Parameter
Value Description
Flanger Pre
Delay
0.0–100.0 ms Adjusts the delay time from
when the direct sound begins
until the flanger sound is
heard.
Flanger Rate # 0.05–10.00 Hz, note Frequency of modulation
Flanger Depth 0–127 Depth of modulation
Flanger
Feedback #
-98– +98 % Adjusts the proportion of the
flanger sound that is fed back
into the effect. Negative (-) set-
tings will invert the phase.
Flanger
Balance #
D100:0W–D0:100W Volume balance between the
direct sound (D) and the
flanger sound (W)
Delay Time 0–2600 ms, note Adjusts the delay time from
the direct sound until the delay
sound is heard.
Delay
Feedback #
-98– +98 % Adjusts the proportion of the
delay sound that is fed back
into the effect. Negative (-) set-
tings will invert the phase.
Delay HF
Damp
200–8000 Hz,
BYPASS
Adjusts the frequency above
which sound fed back to the ef-
fect will be cut. If you do not
want to cut the high frequen-
cies, set this parameter to BY-
PASS.
Delay
Balance #
D100:0W–D0:100W Adjusts the volume balance be-
tween the sound that is sent
through the delay (W) and the
sound that is not sent through
the delay (D).
Level 0–127 Output Level
Parameter
Value Description
Chorus Pre
Delay
0.0–100.0 ms Adjusts the delay time from the
direct sound until the chorus
sound is heard.
Chorus Rate # 0.05–10.00 Hz, note Modulation frequency of the
chorus effect
Chorus Depth 0–127 Modulation depth of the chorus
effect
Chorus
Balance #
D100:0W–D0:100W Volume balance between the di-
rect sound (D) and the chorus
sound (W)
Flanger Pre
Delay
0.0–100.0 ms Adjusts the delay time from
when the direct sound begins
until the flanger sound is heard.
Flanger Rate # 0.05–10.00 Hz, note Modulation frequency of the
flanger effect
Feedback
Delay
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Flanger
Balance W
Balance W
Balance D
Balance D
Feedback
Feedback
Flanger
L in
R in
L out
R out
Balance W
Balance W
Balance D
Balance D
Chorus
Balance W
Balance W
Balance D
Balance D
Flanger Depth
0–127 Modulation depth of the flanger
effect
Flanger
Feedback #
-98– +98 % Adjusts the proportion of the
flanger sound that is fed back
into the effect. Negative (-) set-
tings will invert the phase.
Flanger
Balance #
D100:0W–D0:100W Adjusts the volume balance be-
tween the sound that is sent
through the flanger (W) and the
sound that is not sent through
the flanger (D).
Level 0–127 Output Level
Parameter
Range Explanation
Damper #
0–127 Depth to which damper pedal is
pressed (controls the sympathet-
ic resonance)
Depth # 0–127 Depth of the effect
Octave -3– +3 oct Octave shift amount for the sym-
pathetic resonance
Detune -50– +50 cent Pitch shift amount for the sym-
pathetic resonance
Phase NORMAL,
INVERSE
Phase at which the sympathetic
resonance is generated
Low Damp
Freq
20–1000 Hz Frequency at which the low
range of the sympathetic reso-
nance is cut
Low Damp 1–100 % Amount of attenuation by which
the low range of the sympathetic
resonance is cut (100%: no effect)
High Damp
Freq
1000–10000 Hz Frequency at which the high
range of the sympathetic reso-
nance is cut
High Damp 1–100 % Amount of attenuation by which
the high range of the sympathet-
ic resonance is cut (100%: no ef-
fect)
Time 10–5000 ms Time over which the sympathet-
ic resonance will decay (lower-
ing the Octave setting will make
this more noticeable)
Level 0–127 Output Level
Parameter
Value Description
L in
R in
L out
R out
Sym. Resonance
Fantom-G_r_e.book 182 ページ ２００９年７月２日 木曜日 午後２時５５分