Roland Fantom G8

270
Editing a Sample
This operation raises the level of the entire sample as much as
possible without exceeding the maximum level. In some cases, the
volume of a phrase you resampled (p. 260) will be lower than the
volume of the original phrase. In this case, it is a good idea to boost
the volume by executing the Normalize operation.
1. Press [SAMPLE] to access the Sample Edit screen.
2. Press [F3 (Modify)].
The Sample Modify Menu window will appear.
3. Press
or to select “Normalize,” and then press [F8
(Select)].
To cancel, press [F7 (Cancel)].
4. If you want to replace the current sample with the
normalized sample, press [F6 (Over Write)].
5. Press [F8 (Execute)].
A message will ask you for confirmation.
6. Press [F7 (OK)] to execute.
To cancel, press [F8 (EXIT)].
If [F6 (Over Write)] is off, pressing [F7 (OK)] to execute will
create the edited sample in the lowest unused sample number
in the list.
This operation applies an envelope (time-variant change) to the
volume of the sample. You can also adjust the volume of the entire
sample.
1. Press [SAMPLE] to access the Sample Edit screen.
2. Press [F3 (Modify)].
The Sample Modify Menu window will appear.
3. Press
or to select “Amp,” and then press [F8
(Select)].
To cancel, press [F7 (Cancel)].
4. Use VALUE dial or [INC] [DEC] to set the value.
• Rate: Specifies the rate of volume boost.
This specifies how much boost will be applied relative to the
current volume. The entire sample you select will be boosted.
Value: 0–400%
5. If you want to specify a point, press [F5 (Point)] to light it
into red. Press
or to select a parameter, and then
use VALUE dial or [INC] [DEC] to set the value.
• Current Point: Specifies the currently selected point. Beginning
near the start point, the points will be numbered 1, 2, 3, or 4.
Value: 1–4
• Point 1–4: Location of the current point
• Rate 1–4: Amplification ratio of the current point
Specifies how the volume of each point is to be boosted relative
to the current value.
Value: 0–400%
6. If you want to replace the current sample with the
normalized sample, press [F6 (Over Write)].
7. Press [F8 (Execute)].
A message will ask you for confirmation.
8. Press [F7 (OK)] to execute.
To cancel, press [F8 (EXIT)].
If [F6 (Over Write)] is off, pressing [F7 (OK)] to execute will
create the edited sample in the lowest unused sample number
in the list.
Maximizing the Volume of a
Sample (Normalize)
Amp
Fantom-G_r_e.book 270 ページ ２００９年７月２日 木曜日 午後２時５５分