Roland Fantom Owner's Manual

16
Taking advantage of the Fantom
Can I switch the rotary speed by pressing a
pedal?
Yes. The function that allows you use MIDI messages to make
these changes in realtime to the Multi-effects parameters is
called the Multi-effects Control.
Use the following procedure to make settings.
1. Select a patch that uses 08: ROTARY as the multi-effect.
2. Set the Pedal 1/2 Assign parameter (SYSTEM/Controller) to
“FOOT TYPE.”
3. Set the following parameters (PATCH/MFX Control).
• Source: FOOT TYPE
• Destination: SPEED
• Sens: +63
How can I change the rotary speed according
to the LFO frequency?
Use matrix control instead of using multi-effect control.
Use the following procedure to make settings.
1. Select a patch that uses 08: ROTARY as the multi-effect.
2. Set the following parameters (PATCH/MFX Control).
• Source: OFF
• Destination: SPEED
• Sens: 0
3. Set the following parameters (PATCH/Matrix Control).
• Source: LFO 1
• Destination: MFX CTRL 1
• Sns: +63
• Tone: Assign a check mark to each tone processed by the
effect
Can I use the modulation lever to shift
between tones?
Yes. Use the following procedure to make matrix control
settings.
1. Select a patch.
2. Select the waveforms for the two tones (Tone 1 and Tone 2)
that you want to shift between.
3. Set the TMT Vel Control parameter (PATCH/TMT) to “OFF.”
4. Set the Vel Range Lower/Upper parameter as follows.
Tone 1 Tone 2
• Lower: 1 64
• Upper: 63 127
To shift smoothly between tones, set the Vel Fade Width Lower
or Upper parameter (PATCH/TMT). The higher the values set,
the smoother the switch is between the Tones.
5. Set the following parameters (PATCH/Matrix Control).
• TMT Control Sw parameter: ON
• Source: MODULATION
• Destination: TMT
• Sns: +63
• Tone: Assign a check mark to Tone 1 and Tone 2
6. While playing the keyboard, push the modulation lever away
from yourself to switch from Tone 1 to Tone 2.
How can I synchronize the LFO frequency to
the tempo of the internal sequencer?
Use the following procedure to make settings.
1. Set the Patch Clock Source parameter (PATCH/General) to
“SEQUENCER.”
2. For each tone, set the following parameters (PATCH/LFO).
• 1:Rate: Set as a note value relative to the tempo to which you
will synchronize
• 1:Pitch Depth
• 1:TVF Depth
• 1:TVA Depth
• 1:Pan Depth
3. Set the Sync Mode parameter (SYSTEM/Sequencer) to
“MASTER.”

Roland Fantom Specifications

General

Brand	Roland
Model	Fantom
Category	Synthesizer
Language	English