Roland FC-300 - Storing Pedal Settings; Switching Pedal Settings Simultaneously

26
Control Change Mode
The FC-300 can store up to five different configurations of settings made for all of the
pedals ( “Change the Pedal Settings” (p. 24)) in Control Change mode. These
configurations are called pedal settings, and you can switch them as needed.
1
After completing the pedal settings (p. 24), press [WRITE] in the top screen of
the Control Change Mode.
2
Select the number (1–5) for the pedal settings you want to store with VALUE
[] [].
3
Press [WRITE].
“Sure?” appears in the display.
4
If you want to write the setting, press [WRITE]; if you want to cancel the
procedure, press [EXIT].
1
With the Control Change Mode screen displayed, press VALUE [ ] [ ].
The pedal settings are switched, and the current pedal setting number is indicated in
the BANK/NUMBER display.
Storing Controller Numbers Assigned to the Pedals
(Pedal Settings)
Switching Control Numbers Assigned to the Pedals
Simultaneously
The store-destination
of the pedal setting
FC-300_e1.book 26 ページ ２００７年４月２４日 火曜日 午前１０時１０分